001 5800co opening sensor for tamper 1

Honeywell 5800CO—Tamper Error

A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your Honeywell 5800COMBO carbon monoxide detector, follow the instructions below.

 

Step-by-Step Instructions:

1. Turn the sensor counter-clockwise to remove from baseplate.
001 5800co opening sensor for tamper 1
2. Align the sensor over the baseplate, and turn clockwise while pressing against the baseplate to reinstall. When the sensor snaps into place, the tamper sensor should detect the error is corrected
002 5800co closing sensor for tamper 1

Comments are closed.