Troubleshooting the Kwikset 620 Smart Door Lock
Below are some common troubleshooting tips for the Kwikset 620 smart door lock. If the device is not functioning correctly, follow the steps below for troubleshooting the Z-Wave device not enrolling, and if the issue persists, delete the Z-Wave device from your system and re-enroll it.
The Kwikset 620 is Not Enrolling:
- • Ensure the device is powered by a wall outlet or high-quality batteries with sufficient charge.
- • The Kwikset 620’s communication range is 25 feet. If the panel is too far away, an outlet-powered Z-Wave device can act as a bridge.
- • Power cycle the system if the problem persists by removing power from the device and waiting 2 minutes before returning power. Then, try again to enroll the device.
- • If all the above do not correct the issue, a factory reset may be required.
How to Factory Reset a Kwikset 620:
- Remove the battery pack from the lock.
- Reinsert the battery pack while holding the Program button on the lock.
- Continue holding the Program button for 30 seconds until the lock beeps and the status LED begins to flash red.
- After a few seconds, the door will initiate the handing sequence to signal a successful reset.
- If the problem persists, verify that remote commands can be sent to other Z-Wave devices in the network.
How to Delete a Kwikset 620 from a Z-Wave Network:
- Place the Z-Wave controller into Delete mode.
- Press the A button on the lock one time.
If you experience any trouble with these steps, please text a Support Representative any time at 317-399-5748