2GIG-PIR1E-345—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your 2GIG-PIR1E-345 motion detector, follow the instructions below.

Step-by-Step Instructions:

  1. Remove off of base.

001 sensor off mount
2. Remove the Phillips head screw at the bottom of the sensor.
002 bottom screw

3. Open the sensor from the bottom.

4. Locate the hinges at the top of the sensor, and fit them underneath the brackets on the base.
003a.1 backplate003b.1 inside
5. Swing the sensor back into the base, then replace the screw to securely fastens the device closed.
004 restored

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.