Honeywell 5853—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your Honeywell 5853 glass break sensor, follow the instructions below.

 

5853

Step-by-Step Instructions:

  1. With a small flat blade screwdriver press and twist into the latch slot on the top of the sensor
  2.  The lid will flip down.
  3.  Close lid.
  4.  If necessary clear the trouble on your panel manually

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.