Wireless PowerG Smoke Detector PG9926
When it is time to replace the battery in your DSC PG9926 smoke detector, you will see an alert on your system panel.
Follow the instructions below to replace your battery and clear the alert from your system. The DSC PG9926 smoke detector requires a CR123A 3-volt lithium battery, which can be purchased from Indiana Alarm, local hardware store, mass retailer, or battery store.
Step-by-Step Instructions:
1. Open detector.
2. Open battery cover.
3. Connect battery to terminals, verify correct polarity.
4. Close the battery cover, and place the detector on the mounting bracket.
Note: After restoring a low battery trouble the system may takeup to 15 minutes to clear the trouble.
Note: After restoring a low battery trouble the system may takeup to 15 minutes to clear the trouble.
Connect with Indiana Alarm