Honeywell 5800CO—Tamper Error


If you’re encountering a tamper error on your Honeywell 5800COMBO carbon monoxide detector, it means the panel believes the sensor cover isn’t securely attached. Resolve this issue by following the step-by-step instructions provided below.

 

Step-by-Step Instructions:

1. Turn the sensor counter-clockwise to remove from baseplate.
001 5800co opening sensor for tamper 1
2. Align the sensor over the baseplate, and turn clockwise while pressing against the baseplate to reinstall. When the sensor snaps into place, the tamper sensor should detect the error is corrected
002 5800co closing sensor for tamper 1

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.