Honeywell 5800PIR-RES—Tamper Error
A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your Honeywell 5800PIR-RES motion detector, follow the instructions below.
1. Press the bottom tab to remove the front cover.
2. Take note of the tamper button, which must be pressed by the cover to resolve the error. Return the cover to the sensor, starting with the side opposite the bottom tab, pressing closed until the tab snaps into place.
If you need further assistance, you can call a Support Representative at any time at 317-399-5748.