How to Fix Panel Communication Failure on the GC2 Panel

This means your system is not communicating with our Central Station and we won’t receive signals for any alarm activity until communication is restored. Below are possible causes as to why your system is showing a communication failure, as well as some tips on fixing the cause.
  • Make sure your alarm system has power. If you are experiencing a prolonged power outage, the system will come back up when power is restored.
  • If your power has recently been out, the panel battery may be too weak to allow your cell to send signals. Allow 24 hours to recharge the battery.
  • Make sure your plug is connected securely to its outlet.
  • Make sure the outlet is supplying power – you can check this by plugging something else into this outlet to see if it’s receiving power.

If there is an interruption of cell service in your area, your system’s communication could be impacted temporarily. Ensure that your Wi-Fi is connected as a backup in this event.

  • Large metal objects and appliances that generate radio frequency can interfere with signaling. If you identify these objects around your alarm system, try increasing their distance from your system if it’s safe to do so.
  • It’s best if your system is located near an exterior wall, above ground (not in a basement), and not in the middle of a large structure (like an interior closet far from exterior walls).

If your communication failure is caused by a system malfunction, you can try to power cycle the system:

  1. Completely power down the panel and the module.
  2. Wait 2 minutes, then power the panel back up.
  3. Test your system to confirm whether communication has been restored. Remember to place the system on a test to avoid a false alarm. 
See below to review steps to power cycle your GC2 Go Control Panel. If communication failure continues, call us at 317-399-5748 for help.

1. Disarm with the master code, then unplug the power supply.
gc transformer 2

2. Remove the top screw on top of Go Control, and pry open slots with a screwdriver.
001 2gig gc2 screw top
3. Gently pull the front cover down, and hang it from plastic strap on the backplate.
002 gc2 hang from strap
4. Unplug the battery cable from circuit board, then plug it back in.
003 gc2 replace battery

5. Reassemble touchscreen, and plug in the power supply.
gocontrol small