PG9303—Battery Replacement

When it is time to replace the battery in your door/window sensor, you will see an alert on your system panel.

The DSC PG9303 door/window sensor requires a 3-volt lithium CR2450 Panasonic battery, which can be purchased from Indiana Alarm, local hardware store, mass retailer, or battery store.

 

Step-by-Step Instructions:

1. Locate the sensor with a low battery on either your system panel.

2. Open the cover by inserting a coin into the slot, then twist to remove it. If a coin is not available, insert a 4mm flat screwdriver into each slot of the plastic cover, then twist to open each side.

open cover

3. Remove and replace the 3-volt lithium CR2450 Panasonic battery.

pg9303 remove batterypg9303 replace battery

4. Make sure the area where the batteries are stored is clean and there is no corrosion.

5. Place the cover back on starting with the opposite end from which it was opened. You should hear a snapping sound if it closes correctly.

6. Check if the low battery status has cleared. This could take up to 15 minutes.