PG9914—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC PG9914 PIR motion detector, follow the instructions below.

 

Step-by-Step Instructions:

1. To open the cover, remove the locking screw from the bottom, then press the tab at the bottom of the sensor to remove the cover.
dsc pg9914 secure with screw 1
2. Ensure the battery is correctly installed and that there are no loose springs or obstructions preventing the cover from fitting snugly with the motion sensor.
dsc pg9914 battery replacement 1

3. Close the device cover, ensuring the cover snaps completely into place and conforms with the sensor.

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.