DSC PG9926—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC PG9926 smoke detector, follow the instructions below.

pg9926

Step-by-Step Instructions:

  1. Twist detector off it’s base.
  2. Ensure cover on battery is closed.
  3. Line detector back on it’s base and twist.

 

NOTE: Verify tamper is clear from the panel. This could take 15 minutes to clear.

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.