DSC PG9936—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC PG9926 smoke detector, follow the instructions below.

 

Step-by-Step Instructions:

1. Remove the detector from its mounting base by twisting the detector counterclockwise.

2. Re-install the detector on its mounting base by turning the detector clockwise until the mating marks align.

pg9936

NOTE: Verify tamper is clear from the panel. This could take 15 minutes to clear.

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.