PG9985—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC PG9985 flood sensor, follow the instructions below.

 

Step-by-Step Instructions:

1. Insert a flat-edged screwdriver into the slot and push upward to remove the cover, then remove the screw and separate the cover from the base.
dsc pg9945 open device
2. Ensure the battery is correctly installed and that there are no loose springs or obstructions preventing the cover from fitting snugly with the sensor.
dsc pg9945 remove and replace battery 1
3. Close the device cover, ensuring the cover snaps completely into place and conforms with the sensor.
dsc pg9945 unscrew and remove cover 1

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.