QS1231-840—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your QS1231-840 motion detector, follow the instructions below.

 

Step-by-Step Instructions:

1. Remove the sensor from the wall by pushing the bottom tab in and lifting the sensor off.
001 qs1231 840 open

2. Note that the black lever is what reads the tamper.

3. To correctly close the sensor, line up the two holes on the sensor with the two tabs on the baseplate, and swing the bottom of the sensor onto the baseplate until it snaps into place.
002

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.