SMKT3-345—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your SMKT3-345 smoke detector, follow the instruction below.

 

Step-by-Step Instructions:

1. Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

001 2gig smkt3 345 smoke detector tamper
2. You may need to clear the error from the panel memory.

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.