WLS922-433—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC WLS922-433 glass break sensor, follow the instructions below.

wls912

Step-by-Step Instructions:

  1. Firmly push the sensor as shown above to release it from its base.
  2. Flip sensor over and check the small black tamper pin
  3. Slide unit back on base
  4. Check to see if tamper is cleared from the system.

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.