WS4904P—Tamper Error


A tamper error occurs when the panel is reading that the sensor’s cover is not attached properly. To address the tamper error on your DSC WS4904P PIR motion detector, follow the instructions below.

 

Step-by-Step Instructions:

  1. Using a Phillips-head screwdriver remove the screw located at the bottom of the detector, then slide it upward to remove it from the backing.
md slide upward.jpg

2.Slide the detector back onto the wall plate.

md replace screws.jpg

3.Secure detector to plate with screw.

4.Check if the tamper status has cleared.

 

If you need further assistance, you can call a Support Representative at any time at 317-399-5748.